Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY

(a) When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.

OK:

Malfunction disappears.

HINT:

  • Connect the connectors to the front No. 2 speaker assemblies.
  • When there is a possibility that either the right or left front No. 2 speaker assembly is defective, inspect by interchanging the right one with the left one.
  • Perform the inspection above on both the LH and RH sides.

2. INSPECT FRONT NO. 4 SPEAKER ASSEMBLY (for 7 Speakers)

(a) Temporarily replace the front No. 4 speaker assembly with a new or normally functioning one.

OK:

Malfunction disappears.

HINT:

Connect the connectors to the front No. 4 speaker assembly.

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Vehicle Stability Control System: Brake Actuator Operation Sound is Loud during Initial Check
    CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration. Click here PROCEDURE 1. PERFORM ROAD TEST (a) After turning the ignition switch to ON, compare the operating sound of the bra ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2021 Copyright www.ttundra.com
    0.0175