INSTALLATION PROCEDURE 1. INSTALL STEREO COMPONENT TUNER ASSEMBLY (w/ Satellite Radio)
2. INSTALL NO. 2 RADIO RECEIVER BRACKET (a) w/o Satellite Radio: Install the No. 2 radio receiver bracket with the 3 bolts. Torque: 3.5 N·m {36 kgf·cm, 31 in·lbf} (b) w/ Satellite Radio: Install the No. 2 radio receiver bracket with the 5 bolts. Torque: 3.5 N·m {36 kgf·cm, 31 in·lbf} 3. INSTALL NO. 1 RADIO RECEIVER BRACKET (a) w/o Satellite Radio: Install the No. 1 radio receiver bracket with the 3 bolts. Torque: 3.5 N·m {36 kgf·cm, 31 in·lbf} (b) w/ Satellite Radio: Install the No. 1 radio receiver bracket with the 5 bolts. Torque: 3.5 N·m {36 kgf·cm, 31 in·lbf} 4. INSTALL NO. 1 NAVIGATION WIRE (w/ Satellite Radio)
5. INSTALL NAVIGATION RECEIVER ASSEMBLY (a) Connect each connector. (b) Insert the navigation receiver assembly with bracket and attach the 2 guides and 3 clips on its backside. NOTICE: When inserting the navigation receiver, do not press its knobs. (c) Install the navigation receiver assembly with bracket with the 4 bolts. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} 6. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
8. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). |
Toyota Tundra Service Manual > Brake Actuator: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CONNECT TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Start the engine and run it at idle. (c) Select the Active Test mode on the Techstream. HINT: Refer to the Techstream operator's manual for further details. 2. INSPECT ACTUATOR MOTOR OPERATION (a) With ...