Toyota Tundra Service Manual: Acc Cut Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. REMOVE ACC CUT RELAY

(a) Remove the clip.

(b) Detach the 2 clips and remove the cowl side trim board RH.

(c) Remove the relay.

2. INSPECT ACC CUT RELAY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester connection

Condition

Specified Condition

3 - 4

When battery voltage is not applied to terminals 1 and 2

Below 1 Ω

When battery voltage is applied to terminals 1 and 2

10 kΩ or higher

If the result is not as specified, replace the relay.

3. INSTALL ACC CUT RELAY

(a) Install the relay.

(b) Attach the 2 clips to install the cowl side trim board RH.

(c) Install the clip.

    1ur-fe Starting

    Acc Relay

    See More:

    Toyota Tundra Service Manual > Vane Pump(for 1ur-fe): Installation
    INSTALLATION PROCEDURE 1. INSTALL VANE PUMP ASSEMBLY HINT: Before performing the following procedures, move the spacer until the vane pump can be installed. Text in Illustration *a Spacer (a) Install the vane pump assembly with the 2 bolts. Torque: 28 N·m {286 kgf·cm, 21 ft·lbf} 2. INSTALL PRESSU ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.032