Toyota Tundra Service Manual: Acc Relay

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Starting / Acc Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT MAIN BODY ECU (ACC RELAY)

(a) Measure the resistance of the ACC relay circuit.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

DD-47 - DD-8

When battery voltage is not applied between DD-45 and DD-62

10 kΩ or higher

When battery voltage is applied between DD-45 and DD-62

Below 1 Ω

If the result is not as specified, replace the main body ECU.

    Acc Cut Relay

    Ignition Switch

    See More:

    Toyota Tundra Service Manual > Airbag System: Short in D Squib Circuit (B1800-B1803)
    DESCRIPTION The driver side squib circuit consists of the airbag sensor assembly, spiral with sensor cable sub-assembly and horn button assembly. The circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the driver side squib ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0137