INSTALLATION PROCEDURE 1. INSTALL IGNITION SWITCH ASSEMBLY
2. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt) 3. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column) 4. INSTALL STEERING COLUMN ASSEMBLY (a) for Manual Tilt: (See page (b) for Manual Tilt and Manual Telescopic Steering Column: (See page
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
Toyota Tundra Service Manual > Steering Knuckle: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. PROCEDURE 1. INSTALL KNUCKLE GREASE RETAINER CAP LH (for 2WD) (a) Using a brass bar and hammer, tap in a new retainer cap. NOTICE: The retainer cap is a no ...
