REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After
turning the ignition switch off, waiting time may be required before
disconnecting the cable from the battery terminal. Therefore, make sure
to read the disconnecting the cable from the battery terminal notice
before proceeding with work (See page 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 3. REMOVE STEERING COLUMN ASSEMBLY (a) for Manual Tilt: (See page
(b) for Manual Tilt and Manual Telescopic Steering Column: (See page
4. REMOVE UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt) 5. REMOVE UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column) 6. REMOVE IGNITION SWITCH ASSEMBLY  (a) Detach the 2 claws and remove the ignition switch from the steering lock. |
Toyota Tundra Service Manual > Audio And Visual System: Parking Brake Switch Circuit
DESCRIPTION This circuit is from the parking brake switch assembly to the radio and display receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK PARKING BRAKE SWITCH ASSEMBLY (a) Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Touch Switch in Operation Check (See page )] (b) Check that ...
