Toyota Tundra Service Manual: Starter Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. REMOVE STARTER RELAY (ST)

(a) Remove the engine room relay box cover.

(b) Remove the starter relay from the engine room relay block.

2. INSPECT STARTER RELAY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Terminal Connection	Condition	Specified Condition
3 - 5	When battery voltage is not applied to terminals 1 and 2	10 kΩ or higher
3 - 5	When battery voltage is applied to terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the relay.

3. INSTALL STARTER RELAY

Toyota Tundra Service Manual > Occupant Classification System: Rear Occupant Classification Sensor LH Collision Detection (B1787)
DESCRIPTION DTC B1787 is set when the occupant classification ECU receives a collision detection signal, which is sent by the rear occupant detection sensor LH when an accident occurs. DTC B1787 is also set when the front seat frame with adjuster RH is subjected to a strong impact, even if an actual ...

Toyota Tundra Owners Manual