DISASSEMBLY PROCEDURE 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY
| (a) Remove the nut and disconnect the lead wire from the magnet starter switch. |
|
| (b) Remove the 2 nuts from the starter drive housing while holding the magnet starter switch. |
|
| (c)
Pull the magnet starter switch and while lifting the front part of the
magnet starter switch, release the plunger hook from the drive lever and
remove the magnet starter switch. | |
2. REMOVE STARTER YOKE ASSEMBLY
| (a) Using a T25 "TORX" socket wrench, remove the 2 bolts. |
|
| (b) Pull out the starter yoke together with the starter commutator end frame. |
|
| (c) Remove the 2 screws and commutator end frame from the starter yoke. |
|
| (d) Pull the starter yoke out of the starter commutator end frame.
NOTICE: While holding down the lead wire, remove the starter commutator end frame. |
|
3. REMOVE STARTER BRUSH HOLDER ASSEMBLY
| (a)
Using a screwdriver, pry the end of the spring away from each brush and
pull out the 4 brushes from the brush holder so that they are held in
place by the springs. | |
(b) Remove the brush holder. 4. REMOVE STARTER ARMATURE ASSEMBLY
| (a) Remove the starter armature from the starter yoke. |
|
5. REMOVE STARTER ARMATURE PLATE
| (a) Remove the starter armature plate from the starter drive housing or starter yoke. |
|
6. REMOVE PLANETARY GEAR |
(a) Remove the 3 planetary gears from the starter center bearing clutch. |
|
7. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
| (a) Remove the starter center bearing clutch with the starter pinion drive lever and rubber seal from the starter drive housing. |
|
(b) Remove the starter pinion drive lever and rubber seal from the starter center bearing clutch. | 
