REASSEMBLY PROCEDURE 1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
(b) Install the starter pinion drive lever and rubber seal to the starter center bearing clutch. (c) Install the starter center bearing clutch together with the starter pinion drive lever and rubber seal into the starter drive housing. 2. INSTALL PLANETARY GEAR
(b) Install the 3 planetary gears. 3. INSTALL STARTER ARMATURE ASSEMBLY
4. INSTALL STARTER BRUSH HOLDER ASSEMBLY
5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
6. INSTALL STARTER ARMATURE PLATE (a) Install the starter armature plate to the starter yoke. NOTICE: Install the starter plate so that the keyway is positioned between key-A and key-B. ![]() 7. INSTALL STARTER YOKE ASSEMBLY
8. INSTALL MAGNET STARTER SWITCH ASSEMBLY
(b) Hang the plunger of the magnet starter switch onto the drive lever from the upper side.
|
Toyota Tundra Service Manual > Pre-collision System: Stop Light Relay Circuit (C1A4B)
DESCRIPTION The skid control ECU (brake actuator assembly) sends a stop light operation request signal to the stop light relay (stop light switch assembly). If the skid control ECU (brake actuator assembly) detects a malfunction in the stop light relay circuit, the millimeter wave radar sensor assem ...