Toyota Tundra Service Manual: Disassembly

(a) Remove the nut and disconnect the lead wire from the magnet starter switch.

(b) Remove the 2 nuts from the starter drive housing while holding the magnet starter switch.

(a) Using a T25 "TORX" socket wrench, remove the 2 bolts.

(c) Remove the 2 screws and starter commutator end frame from the starter yoke.

NOTICE:

While holding down the lead wire, remove the starter commutator end frame.

(a) Using a screwdriver, pry the end of the spring away from each brush and pull out the 4 brushes from the brush holder so that they are held in place by the springs.

(a) Remove the starter armature from the starter yoke.

(a) Remove the starter armature plate from the starter center bearing clutch or starter yoke.

(b) Remove the 3 planetary gears from the starter center bearing clutch.

(c) Remove the starter center bearing clutch together with the starter pinion drive lever and rubber seal from the starter drive housing.