REASSEMBLY PROCEDURE 1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
(b) Install the starter pinion drive lever and rubber seal to the starter center bearing clutch. (c) Install the starter center bearing clutch together with the starter pinion drive lever and rubber seal to the starter drive housing.
(e) Install the 3 planetary gears. 2. INSTALL STARTER ARMATURE ASSEMBLY (a) Install the starter armature to the starter yoke. NOTICE: The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed causing the magnet to break. 3. INSTALL STARTER BRUSH HOLDER ASSEMBLY
4. INSTALL STARTER YOKE ASSEMBLY
(b) Install the starter commutator end frame with the 2 screws. Torque: 1.5 N·m {15 kgf·cm, 13 in·lbf}
(d) Using a T25 "TORX" socket wrench, install the 2 bolts. Torque: 6.0 N·m {61 kgf·cm, 53 in·lbf} 5. INSTALL MAGNET STARTER SWITCH ASSEMBLY
(b) Hang the plunger of the magnet starter switch onto the drive lever from the upper side. (c) Install the magnet starter switch with the 2 nuts. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} (d) Connect the lead wire to the magnet starter switch with the nut. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} |
Toyota Tundra Service Manual > Lane Departure Alert System: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART LANE DEPARTURE ALERT SYSTEM DTC No. Detection Item Link C1A47 Steering Angle Sensor C1AA0 Front Camera Module Circuit C1AA1 FCM Destination Information Unmatched C1AA2 Vehicle Speed Tolerance Malfunction C1AA3 Vehicle Speed Sensor Circuit C1AA4 Yaw Rate Sensor Circuit C ...