REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After
turning the ignition switch off, waiting time may be required before
disconnecting the cable from the battery terminal. Therefore, make sure
to read the disconnecting the cable from the battery terminal notice
before proceeding with work (See page 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 3. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH (See page
4. REMOVE STARTER COVER
5. REMOVE STARTER ASSEMBLY
(b) Disconnect the starter connector. (c) Remove the nut and disconnect the starter wire.
|
Toyota Tundra Service Manual > Transfer Assembly: Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Coat all of the sliding and rotating surfaces with Toyota Genuine Transfer gear oil LF 75W or equivalent before reassembly. PROCEDURE 1. INSTALL TRANSFER CASE OIL SEAL (a) Using SST and a hammer, tap in a new transfer case oil seal as shown in the illustratio ...