Toyota Tundra Service Manual: Manual Shifting Test

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Automatic Transmission System / Manual Shifting Test

MANUAL SHIFTING TEST

1. MANUAL SHIFTING TEST

HINT:

Through this test, it can be determined whether the trouble occurs in an electrical circuit or if it is a mechanical problem in the transmission.
If any abnormalities are found in the following test, the problem is in the transmission itself.

(a) Disconnect the connector of the transmission wire.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the transmission wire. The gear positions can then be changed mechanically with the shift lever.

(b) Drive the vehicle with the transmission wire disconnected. Move the shift lever to each position to check whether the gear position changes as shown in the table below.

Shift Lever Position	Gear Position
P	P
R	R
D	4th

(d) Clear the DTCs (See page ).

See More:

Toyota Tundra Service Manual > Occupant Classification System: Rear Occupant Classification Sensor LH Collision Detection (B1787)
DESCRIPTION DTC B1787 is set when the occupant classification ECU receives a collision detection signal, which is sent by the rear occupant detection sensor LH when an accident occurs. DTC B1787 is also set when the front seat frame with adjuster RH is subjected to a strong impact, even if an actual ...

Toyota Tundra Service Manual: Manual Shifting Test

Initialization

Mechanical System Tests

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual