DISASSEMBLY PROCEDURE 1. FIX OIL PUMP ASSEMBLY ![]() (a) Place the oil pump body on the torque converter clutch. 2. REMOVE CLUTCH DRUM OIL SEAL RING ![]() (a) Remove the 3 oil seal rings. 3. REMOVE STATOR SHAFT ASSEMBLY
4. REMOVE FRONT OIL PUMP BODY O-RING ![]() (a) Remove the O-ring from the oil pump body. (b) Remove the oil pump body from the torque converter clutch. 5. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY 6. INSPECT STATOR SHAFT ASSEMBLY 7. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY 8. REMOVE FRONT OIL PUMP DRIVE GEAR ![]() 9. REMOVE FRONT OIL PUMP DRIVEN GEAR ![]() 10. REMOVE FRONT OIL PUMP OIL SEAL ![]() (a) Using a screwdriver, pry out the oil seal. NOTICE: Be careful not to damage the bushing and oil pump body. |
Toyota Tundra Service Manual > Front Shock Absorber: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (see page ). PROCEDURE 1. TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRI ...