ADJUSTMENT PROCEDURE 1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY  (a) Loosen the bolt of the park/neutral position switch and move the shift lever to N. (b) Align the groove with the neutral basic line. (c) Hold the switch in position and tighten the bolt. Torque: 13 N·m {130 kgf·cm, 9 ft·lbf} (d) After the adjustment, perform the on-vehicle inspection (See page
|
Toyota Tundra Service Manual > Brake Actuator: Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: In case of replacing the skid control ECU, perform the zero point calibration of the steering angle sensor, master cylinder pressure sensor, and yaw rate and deceleration sensor (See page ). PROCEDURE 1. INSTALL BRAKE ACTUATOR ASSEMBLY (a) Tighten the 3 n ...
).
