Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Park / Neutral Position Switch / Removal

REMOVAL

PROCEDURE

1. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Remove the nut and disconnect the cable.

2. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Disconnect the switch connector.

(b) Remove the nut, spring washer and transmission control shaft lever RH.

(c) Using a screwdriver, bend the tabs of the lock washer.

(d) Remove the lock nut and lock washer.

(e) Remove the bolt and switch.

HINT:

Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.
    On-vehicle Inspection

    Shift Lever Assembly(for Column Shift Type)

    See More:

    Toyota Tundra Service Manual > Intuitive Parking Assist System: Operation Check
    OPERATION CHECK 1. CHECK INITIAL CHECK FUNCTION (a) Check the initial check function for the sensor. Approximately 0.4 seconds after the ignition switch has been turned to the ON position and the back sonar or clearance sonar switch assembly has been turned ON, all sensors will be checked by the sys ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0373