Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT COLUMN SHIFT SHIFT LEVER SUB-ASSEMBLY

(a) Disconnect the transmission control switch connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

6 (IG) - 13 (S)

Shift lever in S, "+" or "-"

Below 1 Ω

5 (SFTU) - 11 (E)

Shift lever held in "+" (Up-shift)

4 (SFTD) - 11 (E)

Shift lever held in "-" (Down-shift)

6 (IG) - 13 (S)

Shift lever not in S, "+" or "-"

10 kΩ or higher

5 (SFTU) - 11 (E)

Shift lever in S

4 (SFTD) - 11 (E)

If the result is not as specified, replace the column shift shift lever sub-assembly.

    Disassembly

    Installation

    See More:

    Toyota Tundra Service Manual > Sfi System: Evaporative Emission System Pressure Sensor - Manifold Absolute Pressure Correlation (P106A,P106B)
    DESCRIPTION DTC No. DTC Detection Condition Trouble Area P106A The pressure detected by the canister pressure sensor (Vapor Pressure Pump*) and the pressure detected by the manifold absolute pressure sensor (MAP*) differ by 7 kPa (54 mmHg) or more (2 trip detection logic) Canister pressure sensor (c ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0212