Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Shift Lever Assembly(for Column Shift Type) / Removal

REMOVAL

PROCEDURE

1. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

(See page )

2. REMOVE COLUMN SHIFT ASSEMBLY

(a) Move the shift lever to N.

(b) Disconnect the column shift transmission control cable end from the column shift.

(c) Disconnect the connector and detach the harness clamp.

(d) Using a T30 "TORX" wrench, remove the 3 bolts and column shift.

    Reassembly

    Shift Lever Assembly(for Floor Shift Type)

    See More:

    Toyota Tundra Service Manual > Vehicle Stability Control System: Calibration
    CALIBRATION DESCRIPTION (a) Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration. Replacement Part or Procedure Necessary Procedures Skid control ECU (brake actuator assembly) Perform system variant learning and accele ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.034