Toyota Tundra Service Manual: Disassembly

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Shift Lever Assembly(for Floor Shift Type) / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE SHIFT LEVER CAP

(a) Using a screwdriver, detach the 2 claws and remove the shift lever cap from the upper position indicator housing.

Text in Illustration

*a	Protective Tape

NOTICE:

Be careful not to damage the shift lever cap.

HINT:

Tape the screwdriver tip before use.

2. REMOVE UPPER POSITION INDICATOR HOUSING

(a) Detach the 4 claws and remove the upper position indicator housing from the shift lever assembly.

3. REMOVE POSITION INDICATOR SLIDE COVER

(a) Remove the position indicator slide cover together with the No. 2 position indicator slide cover from the shift lever assembly.

4. REMOVE NO. 2 POSITION INDICATOR SLIDE COVER

(a) Remove the No. 2 position indicator slide cover from the position indicator slide cover.

5. DISCONNECT INDICATOR LIGHT WIRE SUB-ASSEMBLY

(a) Using a thin-bladed screwdriver, release the connector housing retainer.

Text in Illustration

Connector Housing Retainer

Component without harness connected

(Transmission Control Switch)

(b) Using a thin-bladed screwdriver, pull out the 4 (ILL+) and 8 (ILL-) terminals from the rear as shown in the illustration.

6. REMOVE LOWER POSITION INDICATOR HOUSING

(a) Using a small screwdriver, detach the 4 claws and remove the lower position indicator housing from the shift lever assembly.

Text in Illustration

*a	Protective Tape

NOTICE:

Be careful not to damage the lower position indicator housing and shift lever assembly.

HINT:

Tape the screwdriver tip before use.

7. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY

(a) Disconnect the connector and remove the indicator light wire sub-assembly from the lower position indicator housing.

8. REMOVE POSITION INDICATOR LED

(a) Detach the claw and remove the position indicator LED from the lower position indicator housing.

9. REMOVE SHIFT LOCK CONTROL ECU

(a) Disconnect the shift lock solenoid connector.

(b) Detach the 3 claws and remove the shift lock control ECU from the shift lever assembly.

See More:

Toyota Tundra Service Manual > Touch Select 2-4 And High-low System: System Diagram
SYSTEM DIAGRAM Transmitting ECU (Transmitter) Receiving ECU Signal Communication Method Skid control ECU 4 wheel drive control ECU Wheel speed sensor error signal Wheel speed signal Vehicle wheel sensor power supply decline status signal Vehicle speed signal CAN communication system ECM 4 wheel driv ...

Toyota Tundra Service Manual: Disassembly

Components

Inspection

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual