Toyota Tundra Service Manual: Installation

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Shift Lever Assembly(for Floor Shift Type) / Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Temporarily install the transmission floor shift assembly to the body with the 4 bolts.

(b) Fully tighten the 4 bolts in the order shown in the illustration.

Torque:

14 N·m {143 kgf·cm, 10 ft·lbf}

(d) Install the cable outer of the transmission control cable assembly to the shift lever retainer, and then install a new clip.

(e) Connect the control cable end to the shift lever assembly.

Text in Illustration

Ridged

NOTICE:

Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable ridged side of the cable end is facing upward.

2. INSTALL NO. 1 CONSOLE BOX DUCT (w/ Rear Air Duct)

(a) Install the No. 1 console box duct with the 2 clips.

3. ADJUST SHIFT LEVER POSITION

4. INSPECT SHIFT LEVER POSITION

5. INSTALL CONSOLE BOX ASSEMBLY

(See page )

See More:

Toyota Tundra Owners Manual > Adjusting the steering wheel and mirrors: Inside rear view mirror
The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view. Adjusting the height of rear view mirror The height of the rear view mirror can be adjusted to suit your driving posture. Adjust the height of the rear view mirror by moving it up and down. Anti-glar ...

Toyota Tundra Service Manual: Installation

Inspection

On-vehicle Inspection

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual