Toyota Tundra Service Manual: Transmission Control Cable(for Floor Shift Type)

Components

COMPONENTS

ILLUSTRATION

Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Insert the transmission control cable from the vehicle interior, and install the cable retainer with the 2 bolts.

Torque:

5.5 N·m {56 kgf·cm, 49 in·lbf}

(b) Connect the transmission control cable to the shift lever retainer, and install a new clip.

NOTICE:

Make sure to connect the cable end so that the inner cable is not twisted. Confirm that the ridged side of the cable end is facing upward.

(d) Move the shift lever to N.

(e) Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.

(f) Connect the control cable with a new clip and the nut.

Torque:

13 N·m {133 kgf·cm, 10 ft·lbf}

NOTICE:

When connecting the cable to the transmission control shaft lever, make sure the L bracket of the cable faces the inside of the vehicle.

(g) Connect the transmission control cable support with the nut.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

2. ADJUST SHIFT LEVER POSITION

3. INSPECT SHIFT LEVER POSITION

4. INSTALL CONSOLE BOX ASSEMBLY

(See page )

Removal

REMOVAL

PROCEDURE

1. REMOVE CONSOLE BOX ASSEMBLY

(See page )

2. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Move the shift lever to N.

(b) Disconnect the transmission control cable end from the shift lever.

(d) Remove the nut and clip, and disconnect the transmission control cable from the automatic transmission.

(e) Remove the nut and disconnect the transmission control cable support.

(f) Remove the 2 bolts and then pull the transmission control cable into the vehicle to remove it.

Toyota Tundra Service Manual > Window Defogger System: System Diagram
SYSTEM DIAGRAM Communication Table Transmitter Receiver Signal Line Air conditioning control assembly Air conditioning amplifier Rear window defogger switch signal LIN ...

Toyota Tundra Owners Manual