Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Transmission Wire / Inspection

INSPECTION

PROCEDURE

1. INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)

(a) Measure the resistance according to the value(s) in the table below.

HINT:

If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

Standard Resistance:

Tester Connection	ATF Temperature	Specified Condition
2 (OT-) - 13 (OT+)	10°C (50°F)	5 to 8 kΩ
2 (OT-) - 13 (OT+)	25°C (77°F)	2.5 to 4.5 kΩ
2 (OT-) - 13 (OT+)	110°C (230°F)	0.22 to 0.28 kΩ
3 (OT2-) - 14 (OT2+)	10°C (50°F)	5 to 8 kΩ
3 (OT2-) - 14 (OT2+)	25°C (77°F)	2.5 to 4.5 kΩ
3 (OT2-) - 14 (OT2+)	110°C (230°F)	0.22 to 0.28 kΩ

If the result is not as specified, replace the transmission wire.

See More:

Toyota Tundra Service Manual > Trailer Brake Control System: Slider Switch Circuit (C14A0)
DESCRIPTION DTC No. Detection Item INF Code DTC Detection Condition Trouble Area C14A0 Slider Switch Circuit 11 12 13 14 INF Code: 11 With the IG terminal voltage from 11 to 14 V, the manual trailer brake output slider is outside the specified range of zero point (60 seconds after turning the igniti ...

Toyota Tundra Service Manual: Inspection

Components

Installation

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual