Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

(a) Install the spring and check ball body.

(b) Align the hole of the manual valve with the pin of the lever and connect the pin to the manual valve.

Torque:

11 N·m {112 kgf·cm, 8 ft·lbf}

HINT:

Each bolt length is indicated below.

36 mm (1.42 in.) for bolt A

25 mm (0.984 in.) for bolt B

45 mm (1.77 in.) for bolt C

50 mm (1.97 in.) for bolt D

(d) Install the detent spring and detent spring cover with the bolt.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

2. CONNECT TRANSMISSION WIRE

3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

5. ADD AUTOMATIC TRANSMISSION FLUID

(a) Add automatic transmission fluid (See page ).

Toyota Tundra Service Manual > Sfi System: Secondary Air Injection System Switching Valve Stuck Open Bank1 (P2440-P2443)
DESCRIPTION Refer to DTC P0412 (See page ). DTC No. DTC Detection Condition Trouble Area P2440 Cumulative pressure pulsation is 60 kPa (450 mmHg) or more for 2 seconds (1 trip detection logic). Air switching valve (ASV) assembly Open or short in ASV circuit Secondary air injection system piping Pres ...

Toyota Tundra Owners Manual