REMOVAL PROCEDURE 1. DRAIN AUTOMATIC TRANSMISSION FLUID 2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY 3. REMOVE VALVE BODY OIL STRAINER ASSEMBLY 4. DISCONNECT TRANSMISSION WIRE 5. REMOVE TRANSMISSION VALVE BODY ASSEMBLY (a) Remove the bolt, detent spring cover and detent spring.
|
Toyota Tundra Service Manual > Sfi System: Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0057,P0058,P0141,P0161,P102D,P105D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the Heated Oxygen (HO2) sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is turned off. The ECM provides a pulse width modulated co ...
