Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. REMOVE FRONT WHEEL

2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

3. REMOVE FRONT DISC

4. REMOVE FRONT AXLE HUB GREASE CAP LH (for 4WD)

5. INSPECT FRONT AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, measure the looseness near the center of the axle hub.

Maximum looseness:

0.05 mm (0.00197 in.)

NOTICE:

Ensure that the dial indicator is set at a right angle to the measurement surface.

If the looseness exceeds the maximum, replace the axle hub.

6. INSPECT FRONT AXLE HUB RUNOUT

(a) Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.

Maximum runout:

0.03 mm (0.00118 in.)

NOTICE:

Ensure that the dial indicator is set at a right angle to the measurement surface.

If the runout exceeds the maximum, replace the axle hub.

7. INSTALL FRONT AXLE HUB GREASE CAP LH (for 4WD)

8. INSTALL FRONT DISC

9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

10. INSTALL FRONT WHEEL

Torque:

for Aluminum Wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for Steel Wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}

Toyota Tundra Service Manual > Navigation System: Noise Occurs or Sound Skips when Portable Player Plays
CAUTION / NOTICE / HINT HINT: Perform this check with the portable player volume set at an appropriate level. Make sure there are no obstructions between the portable player and navigation receiver assembly that may block signals, and that the portable player and navigation receiver assembly are not ...

Toyota Tundra Owners Manual