Toyota Tundra Service Manual: Reassembly

Toyota Tundra Service Manual / Engine, Hybrid System / Axle / Front Axle Hub / Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

NOTICE:

Do not allow foreign matter, etc. to contact the ABS rotor bearing.

PROCEDURE

1. INSTALL PLUG (for 2WD)

(a) Using the SST and a hammer, install a new plug.

SST: 09950-60010

09951-00450

SST: 09950-70010

09951-07100

2. INSTALL FRONT AXLE HUB OIL SEAL

(a) Using SST and a press, press in a new oil seal.

SST: 09608-36010

SST: 09950-70010

09951-07100

NOTICE:

Do not damage the oil seal.

3. INSTALL FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY

(a) Using SST and a press, press in a new bearing.

SST: 09608-32010

NOTICE:

Insert 4 bolts into the bearing before installing the axle hub.
Make sure to securely fit the bearing to the axle hub.

4. INSTALL FRONT WHEEL ADJUSTING NUT (for 2WD)

(a) Using SST, install a new adjusting nut.

SST: 09602-60010

Torque:

382 N·m {3895 kgf·cm, 282 ft·lbf}

See More:

Toyota Tundra Service Manual > Sfi System: Cold Start Idle Air Control System Performance (P050A)
DESCRIPTION This monitor will run when the engine is started with the engine coolant temperature at -10 to 50°C (14 to 122°F). The DTC will be stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the idle air control at cold start. When the engine i ...

Toyota Tundra Service Manual: Reassembly

On-vehicle Inspection

Removal

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual