Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / Axle / Rear Axle Shaft / Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR AXLE SHAFT

(a) Using a dial indicator, measure the rear axle shaft runout and flange runout.

Maximum runout:

Shaft runout

1.50 mm (0.0591 in.)

Flange runout

0.05 mm (0.00197 in.)

If the rear axle shaft or flange is damaged or worn, or if the runout is greater than the maximum, replace the rear axle shaft.
    Disassembly

    Installation

    See More:

    Toyota Tundra Service Manual > Navigation System: Route cannot be Calculated
    PROCEDURE 1. SET DESTINATION (a) Set another destination and check if the system can calculate the route correctly. OK: Route can be correctly calculated. OK NORMAL OPERATION NG PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0111