Toyota Tundra Service Manual: Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

NOTICE:

Do not allow foreign matter, etc. to contact the ABS rotor bearing.

PROCEDURE

1. INSTALL BRAKE DRUM OIL DEFLECTOR

(a) Install a new deflector gasket and deflector to the rear axle shaft.

HINT:

Align the 2 oil drain holes.

(b) Temporarily install a washer and nut to 5 new hub bolts as shown in the illustration.

(c) Install the hub bolts by tightening each nut.

(d) Removed the washer and nut from each hub bolt.

2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Position the parking brake plate on a new rear axle hub and bearing.

NOTICE:

Make sure to securely fit the bearing to the parking brake plate.

(b) Using 2 socket wrenches and a press, press in the 4 housing bolts.

3. INSTALL REAR AXLE SHAFT

(a) Install the washer and a new retainer to the axle hub as shown in the illustration.

NOTICE:

  • Install the washer with its tapered surface facing downward.
  • Install the retainer with its chamfered surface facing downward.

(b) Using SST and a press, press in the rear axle shaft.

SST: 09631-12090

SST: 09726-40010

SST: 09951-01100

NOTICE:

Make sure to securely fit the bearing to the rear axle shaft.

4. INSTALL REAR AXLE SHAFT SNAP RING

(a) Using a snap ring expander, install a new snap ring.

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Pre-collision System: Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART Pre-collision System DTC No. Detection Item Link C1A02 Vehicle Information Not Obtained C1A10 Front Radar Sensor C1A11 Front Radar Sensor Incorrect Axial Gap C1A14 Front Radar Sensor Beam Axis Not Adjusted C1A46 Yaw Rate Sensor C1A47 Steering Angle Sensor C1A4A Skid Con ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0096