INSTALLATION CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. INSTALL KNUCKLE GREASE RETAINER CAP LH (for 2WD)
2. INSTALL STEERING KNUCKLE OIL SEAL LH
3. INSTALL STEERING KNUCKLE LH (a) Install the front suspension upper arm to the steering knuckle with the nut. Torque: 110 N·m {1122 kgf·cm, 81 ft·lbf} (b) Install a new clip. HINT: If the holes for the clip are not aligned, tighten the nut up to another 60. 4. CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH
5. CONNECT TIE ROD END SUB-ASSEMBLY LH
6. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (a) Install the front axle hub (see page ). 7. CONNECT FRONT SPEED SENSOR LH
(b) Attach the clip to the steering knuckle. 8. INSTALL FRONT WHEEL Torque: for Aluminum Wheel : 131 N·m {1336 kgf·cm, 97 ft·lbf} for Steel Wheel : 209 N·m {2131 kgf·cm, 154 ft·lbf} 9. CHECK SPEED SENSOR SIGNAL (a) Check the speed sensor signal (see page ). 10. CHECK SRS WARNING LIGHT (a) Check the SRS warning light (see page ). 11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT (a) Inspect and adjust the front wheel alignment (see page ). |
Toyota Tundra Service Manual > Air Conditioning System(for Manual Air Conditioning System): Blower Motor Circuit
DESCRIPTION The blower motor is operated by signals from the air conditioning amplifier. Blower motor speed signals are transmitted by changes in the duty ratio. Duty Ratio: The duty ratio is the ratio of the blower motor OFF time (B) to the total of the blower motor ON and OFF time (A + B). The blo ...