Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / Cruise Control / Cruise Control Main Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT CRUISE CONTROL MAIN SWITCH

(a) w/o Dynamic Radar Cruise Control System:

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a

Component without harness connected

(Cruise Control Main Switch Assembly)

-

-

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 (ECC) - 3 (CCS)

Neutral

10 MΩ or higher

+RES

236 to 244 Ω

-SET

618 to 642 Ω

CANCEL

1510 to 1570 Ω

Main Switch ON

Below 1.5 Ω

Main Switch OFF

10 MΩ or higher

If the result is not as specified, replace the cruise control main switch.

(b) w/ Dynamic Radar Cruise Control System:

(1) Measure the resistance according to the value(s) in the table below.

*a

Component without harness connected

(Cruise Control Main Switch Assembly)

-

-

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 (ECC) - 3 (CCS)

Neutral

10 MΩ or higher

+RES

236 to 244 Ω

-SET

618 to 642 Ω

CANCEL

1510 to 1570 Ω

Main Switch ON

Below 1.5 Ω

If the result is not as specified, replace the cruise control main switch assembly.

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Meter / Gauge System: Lost Communication with Brake System Control Module (U0129)
    DESCRIPTION The combination meter communicates with the skid control ECU via the CAN line. DTC Code DTC Detection Condition Trouble Area U0129 When either of following conditions is detected: 15 seconds have elapsed since engine started and IG voltage 10.5 V or more No communication with skid contro ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0108