INSTALLATION PROCEDURE 1. INSTALL CRUISE CONTROL MAIN SWITCH
(b) Pass the cruise control switch wire under the rib as shown in the illustration. 
(c) Attach the guide. (d) Temporarily install the cruise control main switch with the 2 screws. (e) Tighten the 2 screws to install the cruise control main switch. HINT: Tighten the screws in the order shown in the illustration. (f) Connect the connector. 2. INSTALL STEERING PAD Click here 3. INSTALL LOWER NO. 3 STEERING WHEEL COVER Click here
4. INSTALL LOWER NO. 2 STEERING WHEEL COVER Click here 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 6. CHECK SRS WARNING LIGHT Click here |
Toyota Tundra Service Manual > Automatic Transmission System: Gear 6 Incorrect Ratio (P0729)
DESCRIPTION The ECM uses signals from the output speed sensor SP2 and input speed sensor NT to detect the actual gear position (1st, 2nd, 3rd, 4th, 5th or 6th gear). Then the ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of the shift solenoid va ...
