Toyota Tundra Service Manual: Front Radar Sensor (C1A10)

DESCRIPTION

C1A10 is output when there is an internal malfunction in the millimeter wave radar sensor assembly.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1A10	Front Radar Sensor	While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the internal malfunction of the millimeter wave radar sensor assembly continues for 0.3 seconds or more.	Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

When replacing the millimeter wave radar sensor assembly, make sure to replace it with a new one. If a device which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle, and as a result, a DTC may be stored.
When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Click here

PROCEDURE

1.	REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Replace the millimeter wave radar sensor assembly with a new one.

Click here

(b) Perform millimeter wave radar sensor assembly adjustment.

Click here

2.	CLEAR FOR DTCs (RADAR CRUISE 2)

(a) Clear the DTCs.

Click here

END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE)

Toyota Tundra Service Manual > Power Tilt And Power Telescopic Steering Column System: Vehicles Speed Malfunction (B2624)
DESCRIPTION The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems via CAN communication. Each ECU informs the other ECUs that it is connected to the network by sending a specified signal (periodic signal) onto the communication bus on a regular basis. The multiplex til ...

Toyota Tundra Owners Manual