Toyota Tundra Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Radar Cruise 1*1 / Trouble Codes.

(e) Enter the following menus: Powertrain / Radar Cruise 2*2 / Trouble Codes.

(f) Check for DTCs.

Click here

  • *1: Stored in the ECM
  • *2: Stored in the millimeter wave radar sensor assembly

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Radar Cruise 1*1 / Clear DTCs.

(e) Enter the following menus: Powertrain / Radar Cruise 2*2 / Clear DTCs.

(f) Clear the DTCs.

  • *1: Stored in the ECM
  • *2: Stored in the millimeter wave radar sensor assembly
    Distance Control Switch Circuit

    Fail-safe Chart

    See More:

    Toyota Tundra Service Manual > Rear View Monitor System(for Radio And Display Type): Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Rear View Monitor System DTC Code Detection Item See page C1622 Open or Short Circuit in Back Camera Signal ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0115