CAUTION / NOTICE / HINT HINT:
PROCEDURE
(a) Measure the battery voltage with the ignition switch off. Standard voltage: 11 to 14 V If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
(a) Using the Techstream, check if the CAN communication system is functioning normally. HINT: Refer to CAN Bus Check in CAN Communication System. Click here
OK: CAN communication system is functioning normally.
HINT: Refer to DTC Check / Clear. Click here
(a) Check for DTCs and note any codes that are output. (b) Clear the DTCs. (c) Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.
HINT: Refer to Problem Symptoms Table. Click here
(a) Terminals of ECU Click here (b) Data List / Active Test Click here
NOTICE: If the forward recognition camera has been replaced with a new one, it is necessary to perform Forward Recognition Camera Axis Adjustment. Click here
|
Toyota Tundra Service Manual > Shift Lever Assembly(for Floor Shift Type): On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT SHIFT LEVER POSITION (a) When moving the shift lever from P to R with the ignition switch ON and brake pedal depressed, make sure that it moves smoothly and correctly into position. (b) Start the engine and make sure that the vehicle moves forward after mov ...
