Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

• When replacing the forward recognition camera, replace it with a new one.
• Do not touch the camera lens or the front windshield glass in front of the camera.
• If the forward recognition camera has been struck or dropped, replace it with a new one.
• When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also, the dynamic radar cruise control system, forward recognition camera system, lane departure alert system, pre-collision system may not operate properly due to a difference in the transmissivity or black ceramic border.
• Do not touch the internal components of the forward recognition with heater hood sub-assembly or press on the heater when working on the forward recognition with heater hood sub-assembly.

PROCEDURE

1. REMOVE NO. 1 FORWARD RECOGNITION COVER

(a) Detach the 2 clips and 2 guides and remove the No. 1 forward recognition cover as shown in the illustration. NOTICE: When removing, press the cover parallel to the windshield glass surface and remove.

2. REMOVE FORWARD RECOGNITION LATCH

(a) Detach the 2 claws in the direction indicated by the arrow (1) in the illustration.

(b) Detach the 4 guides in the direction indicated by the arrow (2) in the illustration to remove the forward recognition latch.

3. REMOVE FORWARD RECOGNITION CAMERA

NOTICE:

If the forward recognition camera has been struck or dropped, replace it with a new one.

(a) Disconnect the connector. NOTICE: Do not pull the harness forcibly when disconnecting the connector.

(b) Detach the 4 guides and remove the forward recognition camera as shown in the illustration.

NOTICE:

• Do not apply excessive force.
• If the forward recognition camera bracket is deformed or damaged, replace it together with the windshield glass.

4. REMOVE FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY

NOTICE:

Do not touch the internal components of the forward recognition with heater hood sub-assembly or press on the heater when working on the forward recognition with heater hood sub-assembly.

(a) Disconnect the connector. NOTICE: Do not pull the harness forcibly when disconnecting the connector.

(b) Detach the connector clamp.

(c) Detach the 2 guides and remove the wire harness.

(d) Detach the claw in the direction indicated by the arrow (1) in the illustration.

Heater Area

NOTICE:

Do not press the heater area.

(e) Detach the guide in the direction indicated by the arrow (2) in the illustration to remove the forward recognition with heater hood sub-assembly.