Toyota Tundra Service Manual: Power Source Circuit

DESCRIPTION

This circuit provides power to operate the forward recognition camera.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.	CHECK HARNESS AND CONNECTOR (POWER SOURCE VOLTAGE)

(a) Disconnect the forward recognition camera connector.

*a	Front view of wire harness connector (to Forward Recognition Camera)

(b) Turn the ignition switch to ON.

Standard Voltage:

Tester Connection	Condition	Specified Condition
W9-7 (IGB) - Body ground	Ignition switch ON	11 to 14 V

(d) Connect the forward recognition camera connector.

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.	CHECK HARNESS AND CONNECTOR (FORWARD RECOGNITION CAMERA - BODY GROUND)

(a) Disconnect the forward recognition camera connector.

*a	Front view of wire harness connector (to Forward Recognition Camera)

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
W9-10 (GND) - Body ground	Always	Below 1 Ω

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

REPAIR OR REPLACE HARNESS OR CONNECTOR

Toyota Tundra Service Manual > Seat Belt Warning System: Front Passenger Side Seat Belt Warning Light Malfunction
DESCRIPTION When the ignition switch to ON, the occupant detection ECU sends a signal to the center airbag sensor assembly to indicate the state of the front seat inner belt assembly RH and also whether the front passenger seat is occupied. The center airbag sensor assembly sends those signals to th ...

Toyota Tundra Owners Manual