REMOVAL PROCEDURE 1. REMOVE RADIATOR GRILLE Click here 2. REMOVE MILLIMETER WAVE RADAR WIRE
3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY NOTICE: Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact. (a) for Type A: ![]()
(1) Remove the 2 bolts and screw. (2) Detach the guide and remove the millimeter wave radar sensor assembly. (b) for Type B: ![]()
(1) Remove the 2 bolts and screw. (2) Detach the guide and remove the millimeter wave radar sensor assembly. (c) for Type C: ![]()
(1) Remove the 2 bolts and screw. (2) Detach the guide and remove the millimeter wave radar sensor assembly. |
Toyota Tundra Service Manual > Roof Drip Side Finish Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. When removing the moulding, heat the vehicle body and moulding using a heat light. When replacing a clip, heat the vehicle body and clip using a heat light. Sta ...