Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

(a) Clean the contact surfaces of the rear differential carrier and the rear axle housing.

(b) Install a new gasket and the differential carrier with the 10 washers and 10 nuts.

Torque:

72 N·m {734 kgf·cm, 53 ft·lbf}

NOTICE:

Be careful not to damage the installation surface.

2. INSTALL REAR AXLE SHAFT LH

(a) Install the rear axle shaft LH (See page ).

3. INSTALL REAR AXLE SHAFT RH

HINT:

Use the same procedure described for the LH side.

4. INSTALL PROPELLER SHAFT ASSEMBLY

(a) Install the propeller shaft for 2WD (See page ).

(b) Install the propeller shaft for 4WD (See page ).

5. ADD DIFFERENTIAL OIL

6. INSTALL REAR WHEEL

(a) Install the rear wheels.

Torque:

for Aluminum Wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for Steel Wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}

    Disassembly

    Reassembly

    See More:

    Toyota Tundra Service Manual > Pre-collision System Warning Buzzer: Removal
    REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE INSTRUMENT SIDE PANEL LH Click here 4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Click here 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Click here 6. REMOVE SKI ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0183