REMOVAL PROCEDURE 1. REMOVE REAR WHEEL 2. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft for 2WD (See page ). (b) Remove the propeller shaft for 4WD (See page ). 3. DRAIN DIFFERENTIAL OIL
4. REMOVE REAR AXLE SHAFT LH (a) Remove the rear axle shaft LH (See page ). 5. REMOVE REAR AXLE SHAFT RH HINT: Use the same procedure described for the LH side. 6. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
(b) Remove the gasket. |
Toyota Tundra Service Manual > Vehicle Stability Control System: Stop Light Switch OFF Stuck Malfunction (C1426)
DESCRIPTION The skid control ECU (brake actuator assembly) receives stop light switch assembly signals and uses them to determine whether or not the brakes are applied. The skid control ECU (brake actuator assembly) has a detection circuit that it uses to detect a short in the stop light input signa ...