Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY

(a) Install the differential support with the F and G bolts.

Torque:

100 N·m {1020 kgf·cm, 74 ft·lbf}

(b) Using a jack, slowly raise the front differential carrier assembly to its installation position.

(c) Temporarily install the A, B, C, D and E bolts.

(d) Tighten the A bolt.

Torque:

113 N·m {1152 kgf·cm, 83 ft·lbf}

(e) Tighten the B and C bolts.

Torque:

113 N·m {1152 kgf·cm, 83 ft·lbf}

(f) Tighten the D and E bolts.

Torque:

113 N·m {1152 kgf·cm, 83 ft·lbf}

(g) Connect the differential actuator hose.

(h) Connect the differential actuator connector.

2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

(See page )

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure as the LH side.

4. INSTALL FRONT PROPELLER SHAFT ASSEMBLY

(See page )

5. ADD DIFFERENTIAL OIL

6. INSTALL NO. 1 ENGINE UNDER COVER

7. INSTALL FRONT WHEEL

(a) Install the front wheels.

Torque:

for aluminum wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for steel wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}

    Disassembly

    Reassembly

    See More:

    Toyota Tundra Service Manual > Intuitive Parking Assist System: Clearance Warning ECU Power Source Circuit
    DESCRIPTION This circuit is the power source circuit to operate the clearance warning ECU assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCEDURE 1. CHECK HARNESS AND CONNECTOR (BACK SONAR OR ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0098