Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT WHEELS

2. REMOVE NO. 1 ENGINE UNDER COVER

3. DRAIN DIFFERENTIAL OIL

4. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

(See page )

5. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

(See page )

6. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure as the LH side.

7. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY

(a) Remove the bolt and disconnect the front differential breather tube bracket.

(b) Disconnect the differential actuator hose.

(c) Disconnect the differential actuator connector.

(d) Support the front differential with a jack.

(e) Remove the A, B, C, D and E bolts.

(f) Slowly lower the jack, and remove the front differential carrier.

(g) Remove the F and G bolts, and differential support.

    Reassembly

    Front Differential Carrier Oil Seal(for 4wd)

    See More:

    Toyota Tundra Service Manual > Front Door(for Crewmax): On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FRONT DOOR PANEL SUB-ASSEMBLY LH (a) Check that the clearance measurements of areas A to J are within the standard range. Standard measurement: Area Specified Condition Area Specified Condition A 3.7 to 6.7 mm (0.146 to 0.264 in.) F 0.8 to 3.8 mm (0.0315 to ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0161