Components COMPONENTS ILLUSTRATION ![]() Replacement REPLACEMENT CAUTION / NOTICE / HINT HINT: The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified. PROCEDURE 1. DRAIN DIFFERENTIAL OIL 2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH (a) Remove the front drive shaft (see page 3. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL ![]() (a) Using SST, tap out the 2 oil seals. SST: 09308-10010 4. INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL ![]() (a) Apply MP grease to 2 new oil seals. (b) Using SST and a hammer, tap in the 2 oil seals. SST: 09550-00032 SST: 09950-70010 09951-07100 NOTICE: Make sure the LH and RH oil seals are installed in the proper locations. Standard oil seal depth:
5. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (a) Install the front drive shaft (see page
6. ADD DIFFERENTIAL OIL
|
Toyota Tundra Service Manual > Power Window Control System(w/ Jam Protection Function): Rear Power Window LH does not Operate with Rear Power Window Switch LH
DESCRIPTION If the rear LH side manual UP/DOWN function does not operate, there may be a malfunction in the rear switch LH, the rear motor LH, the master switch, or the harness or connector. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before p ...