INSPECTION PROCEDURE 1. INSPECT FRONT DRIVE SHAFT ASSEMBLY NOTICE: Move the drive shaft while keeping it level.
(b) Check if the inboard joint shaft slides smoothly in the thrust direction. (c) Check if there is excessive play in the radial direction of the inboard joint shaft. (d) Check the boots for damage. |
Toyota Tundra Service Manual > 1ur-fe Starting: Starter Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. REMOVE STARTER RELAY (ST) (a) Remove the engine room relay box cover. (b) Remove the starter relay from the engine room relay block. 2. INSPECT STARTER RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Res ...
