Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (see page ).

PROCEDURE

1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (for Front Differential Side)

(a) Install a new snap ring to the inboard joint shaft.

(b) Coat the spline of the inboard joint shaft assembly with gear oil.

(c) Align the shaft splines and install the drive shaft with a brass bar and hammer. NOTICE: Set the snap ring with the opening side facing downward. Be careful not to damage the oil seal. HINT: Whether the inboard joint shaft is in contact with the pinion shaft or not can be confirmed from the sound or feeling when driving it.

2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (for Axle Hub Side)

(a) Install the drive shaft to the steering knuckle.

NOTICE:

Be careful not to damage the oil seal, boots and dust seal.

3. CONNECT FRONT LOWER BALL JOINT ATTACHMENT

4. INSTALL TIE ROD END SUB-ASSEMBLY

5. INSTALL AXLE HUB NUT

6. INSTALL FRONT AXLE HUB GREASE CAP

7. INSTALL FRONT SPEED SENSOR LH

(a) Install the front speed sensor (see page ).

8. INSTALL NO. 1 ENGINE UNDER COVER

9. INSTALL FRONT WHEEL

(a) Install the front wheels.

Torque:

for aluminum wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for steel wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}

10. ADD DIFFERENTIAL OIL

11. CHECK SPEED SENSOR SIGNAL

(a) Check the speed sensor signal (see page ).

12. CHECK FOR DIFFERENTIAL OIL LEAK

13. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment (see page ).