REMOVAL CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. REMOVE FRONT WHEEL 2. REMOVE NO. 1 ENGINE UNDER COVER
3. DRAIN DIFFERENTIAL OIL
4. DISCONNECT FRONT SPEED SENSOR LH (a) Disconnect the front speed sensor LH (see page ). 5. REMOVE FRONT AXLE HUB GREASE CAP
6. REMOVE AXLE HUB NUT
7. REMOVE TIE ROD END SUB-ASSEMBLY
8. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH
9. DISCONNECT FRONT DRIVE SHAFT ASSEMBLY LH (a) Using plastic-faced hammer, disconnect the drive shaft from the axle hub side. (b) Push the steering knuckle outward and disconnect the drive shaft from the steering knuckle. 10. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
(b) Using a screwdriver, remove the snap ring from the inboard joint shaft. |
Toyota Tundra Service Manual > Rear Door Lock(for Double Cab): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH 2. I ...