Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY

(a) Check that the propeller shaft is not damaged or deformed.

  • If necessary, replace the propeller shaft.

(b) Using a dial indicator, check the propeller shaft runout.

Maximum runout:

0.61 mm (0.0240 in.)

2. INSPECT UNIVERSAL JOINT SPIDER BEARING

(a) Check that the joints move smoothly.

(b) Check the spider bearings for wear and damage.

(c) Check the spider bearing axial play by turning the yoke while holding the shaft tightly.

Maximum bearing axial play:

0.05 mm (0.00197 in.)

  • If necessary, replace the spider bearing.
    Disassembly

    Installation

    See More:

    Toyota Tundra Owners Manual > For safe use: Seat belts
    Make sure that all occupants are wearing their seat belts before driving the vehicle. Correct use of the seat belts Extend the shoulder belt so that it comes fully over the shoulder, but does not come into contact with the neck or slide off the shoulder. Position the lap belt as low as possible ove ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0143