Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / Propeller Shaft / Propeller Shaft Assembly(for 2wd) / Inspection

INSPECTION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSPECT PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

(a) Using a dial indicator, measure the intermediate shaft runout.

Maximum runout:

0.61 mm (0.0240 in.)

If the intermediate shaft runout is more than the maximum, replace the propeller shaft with center bearing assembly.

(b) Using a dial indicator, measure the propeller shaft runout.

Maximum runout:

1.02 mm (0.0402 in.)

If the propeller shaft runout is more than the maximum, replace the propeller shaft with center bearing assembly.

2. INSPECT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

(a) Mount the propeller shaft in a vise.

NOTICE:

Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.

(b) Inspect the spider bearing for wear or damage.

(c) Using a dial indicator, measure the spider bearing axial play by turning the yoke of the flange while holding the shaft tightly.

Maximum bearing axial play:

0.05 mm (0.00197 in.)

If the spider bearing axial play is more than the maximum, replace the spider bearing.

3. INSPECT NO. 1 CENTER SUPPORT BEARING ASSEMBLY

(a) Check that the bearing turns freely.

If the bearing is damaged, worn, or does not turn freely, replace it.

See More:

Toyota Tundra Service Manual > Sfi System: Cold Start Ignition Timing Performance (P050B)
DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC will be set after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the ignition timing at cold start. When the engine is start ...

Toyota Tundra Service Manual: Inspection

Disassembly

Installation

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual