REASSEMBLY PROCEDURE 1. INSTALL PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same installation procedure for both the sleeve yoke side and flange yoke side universal joint spider bearings.
(c) Install the 4 spider bearings to the spider journal portions, and then measure dimension B of the universal joint. NOTICE: When measuring dimension B, fix the spider and spider bearings in a vise and hold them firmly together.
(e) Temporarily install the spider and 2 universal joint spider bearings into the sleeve yoke.
(h) Temporarily install the spider and 2 universal joint spider bearings into the shaft yoke.
(j) Using needle-nose pliers, install the previously selected snap ring into the groove on the shaft yoke. HINT: Use the same installation procedure for the universal joint spider bearing on the opposite side. 2. INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY (a) Coat the splines of the intermediate shaft with MP grease. ![]() (b) Install the center support bearing to the intermediate shaft. Text in Illustration
(d) Install the washer. (e) Clamp the yoke in a vise, and press the bearing into position by installing a new lock nut. Torque: 128 N·m {1300 kgf·cm, 94 ft·lbf} (f) Loosen the lock nut. (g) Tighten the lock nut again. Torque: 128 N·m {1300 kgf·cm, 94 ft·lbf} (h) Using a chisel and hammer, stake the lock nut. 3. INSTALL PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING
(c) Install the 4 spider bearings to the spider journal portions, and then measure dimension B of the universal joint. NOTICE: When measuring dimension B, fix the spider and spider bearings in a vise and hold them firmly together.
(e) Temporarily install the universal joint spider and 2 universal joint spider bearings into the propeller shaft yoke.
(h) Align the matchmarks on the propeller shaft yoke and universal joint yoke, and temporarily install the spider and 2 universal joint spider bearings into the universal joint yoke.
(j) Using needle-nose pliers, install the previously selected snap ring into the groove on the universal joint yoke. HINT: Use the same installation procedure for the universal joint spider bearing on the opposite side. 4. INSPECT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING
(b) Measure each spider bearing's axial play by turning the yoke while holding the shaft tightly. Maximum bearing axial play: 0.05 mm (0.00197 in.) |
Toyota Tundra Service Manual > Rear Center Seat Outer Belt Assembly(for Crewmax): Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY (a) Attach the guide to install the rear center seat outer belt assembly with the nut. Torque: 42 N·m {428 kgf·cm, 31 ft· ...