Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / Propeller Shaft / Propeller Shaft Assembly(for 2wd) / Removal

REMOVAL

PROCEDURE

1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

(a) Place matchmarks on the propeller shaft flange and differential flange.

Text in Illustration

*a

Matchmark

(b) Remove the 4 bolts and 4 nuts. Then disconnect the propeller shaft from the differential side.

(c) w/o Bearing Washer:

Remove the 2 mounting bolts from the crossmember.

(d) w/ Bearing Washer:

Remove the 2 mounting bolts and 2 bearing washers from the crossmember.

(e) Remove the propeller shaft.

(f) for 1UR-FE:

Insert SST into the transmission to prevent oil leakage.

SST: 09325-40010

Text in Illustration

*A

for 1UR-FE

(g) for 3UR-FE:

Insert SST into the transmission to prevent oil leakage.

SST: 09325-60010

Text in Illustration

*A

for 3UR-FE
    Reassembly

    Propeller Shaft Assembly(for 4wd)

    See More:

    Toyota Tundra Service Manual > Airbag System: Short in P/T Squib (LH) Circuit (B1905-B1908)
    DESCRIPTION The front pretensioner LH circuit consists of the airbag sensor assembly and front seat outer belt assembly LH. This circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the front pretensioner LH circuit. DTC No. ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0347