Toyota Tundra Service Manual: Disposal

Toyota Tundra Service Manual / Engine, Hybrid System / Suspension / Front Shock Absorber / Disposal

DISPOSAL

PROCEDURE

1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH

(a) Fully extend the shock absorber rod.

(b) Using a drill, make a hole in the cylinder between A and B shown in the illustration to discharge the gas inside.

CAUTION:

Be careful when drilling because shards of metal may fly about. Always use the proper safety equipment.
For off road type shock absorbers, be extremely careful when drilling it as its gas pressure is much higher than the standard type.

NOTICE:

The gas is colorless, odorless and nonpoisonous.

See More:

Toyota Tundra Service Manual > Vane Pump(for 3ur-fe, 3ur-fbe): Installation
INSTALLATION PROCEDURE 1. INSTALL VANE PUMP ASSEMBLY HINT: Before performing the following procedures, move the spacer until the vane pump can be installed. (a) Install the vane pump with the 2 bolts. Torque: 28 N·m {286 kgf·cm, 21 ft·lbf} 2. CONNECT PRESSURE FEED TUBE (a) Install a new gasket to ...

Toyota Tundra Service Manual: Disposal

Disassembly

Inspection

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual